Mariner 2WD L4-2.3L VIN Z (2005)
2. Disconnect the speed control cable from the speed control actuator pulley.
1
Gently push the retaining spring.
2
Disconnect the speed control cable slug from the speed control actuator pulley.
3. Remove the 3 speed control actuator screws and the speed control actuator.
-
Disconnect the electrical connector.
Installation
CAUTION: A new speed control cable must be installed.
1. Install the speed control actuator and the 3 speed control actuator screws.
-
Tighten to 9 Nm (80 lb-in).
-
Connect the electrical connector.
2. Insert the speed control cable slug into the speed control actuator pulley slot.
1
Gently push the retaining spring.
2
Insert the speed control cable slug completely into the speed control actuator pulley slot.
3. CAUTION:
-
It is necessary to squarely seat the speed control cable cap and seal around the speed control actuator pulley.
-
Incorrect wrapping of the speed control cable around the speed control actuator pulley may result in high idle conditions.
NOTE: Make sure the rubber seal is fully seated onto the speed control cable cap.
Align the speed control cable cap tabs with the slots in the speed control actuator housing.
