Mariner 2WD L4-2.3L VIN Z (2005)
4. Disconnect the speed control cable from the speed control actuator pulley.
1. Gently push the retaining spring.
2. Disconnect the speed control cable slug from the speed control actuator pulley.
Installation
1. Insert the speed control cable slug into the speed control actuator pulley slot.
1
Gently push the retaining spring.
2
Insert the speed control cable slug completely into the speed control actuator pulley slot.
2. CAUTION:
-
It is necessary to squarely seat the speed control cable cap and seal around the speed control actuator pulley.
-
Incorrect wrapping of the speed control cable around the speed control actuator pulley may result in high idle conditions.
NOTE: Make sure the rubber seal is fully seated onto the speed control cable cap.
Align the speed control cable cap tabs with the slots in the speed control actuator housing.
