Mariner 2WD L4-2.3L VIN Z (2005)
Drive Belt Tensioner: Service and Repair
Accessory Drive Belt Tensioner
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the 5 bolts and the RH splash shield.
^
To install, tighten to 9 Nm (80 inch lbs.).
3. Rotate the accessory drive belt tensioner clockwise and remove the accessory drive belt.
4. Remove the 2 bolts and the accessory drive belt tensioner.
^
To install, tighten to 25 Nm (18 ft. lbs.).
5. To install, reverse the removal procedure.