Mariner 2WD L4-2.3L VIN Z (2005)
1. CAUTION: Make sure the vapor tube clicks into place when installing the tube. To make sure the tube is fully seated, pull on the tube.
NOTE: Apply clean engine oil to the end of the tube before inserting the tube into the connector.
Install the fuel vapor control tube assembly valve and install the fuel vapor tube quick connect coupling onto the fuel filter vapor tube.
-
Pull on the fitting to make sure it is fully engaged.
2. Press the fuel vapor control tube assembly valve quick connect coupling onto the EVAP canister fitting until it locks in place and is fully seated.
-
Pull on the coupling to make sure it is fully engaged.
3. Press the fuel vapor tube quick connect coupling onto the fuel vapor control tube assembly valve fitting until it locks in place and is fully seated.
-
Pull on the fitting to make sure it is fully engaged.
4. Install the fuel tank.
5. Carry out a leak test. See: Testing and Inspection/Evaporative Emission System Leak Test
6. Carry out the evaporative emission repair verification drive cycle. See: Testing and Inspection/Evaporative Emission Repair Verification Drive
Cycle
