Mariner 2WD L4-2.3L VIN Z (2005)
5. CAUTION: Do not handle the passenger air bag module by grabbing the edges of the deployment door.
Through the glove box opening, push up to release the 3 lower deployment door clips (2 shown) from the instrument panel and push the lower end
of the passenger air bag module out of the instrument panel, so the clips do not engage again.
6. Push down at the top of the deployment door, release the 3 clips and remove the passenger air bag module.
Installation
1. NOTE: Make sure the J-clips are in place before positioning the passenger air bag module to the instrument panel.
Install the passenger air bag module trim cover into the instrument panel.
-
With the alignment pins positioned to the instrument panel, push in, seating the top (top shown) and bottom deployment door retainers.
2. Install the 4 passenger air bag module bolts.
-
Tighten to 8 Nm (71 lb-in).
3. Connect the passenger air bag module electrical connector.
4. Close the glove compartment door.
5. Repower the system.
