Mariner 2WD L4-2.3L VIN Z (2005)
Removal
WARNING:
-
Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module.
This will reduce the risk of injury in the event of an accidental deployment.
-
To reduce the risk of personal injury, do not use any memory saver devices.
-
Do not separate components.
CAUTION:
-
There are 2 occupant classification sensor (OCS) system service kits available for this vehicle (base seat and heated seat). Always make
sure the correct OCS service kit is installed.
-
It is necessary to rezero the OCS system when a front passenger seat cushion is disassembled, a new trim cover installed, or an OCS
service kit is installed. A diagnostic tool is used to trigger the active command to carry out rezeroing of the OCS system.
NOTE:
-
The heated seat element on the front passenger seat cushion is not serviceable separately. If a new heated seat element is needed on the front
passenger seat cushion, a new occupant classification sensor (OCS) service kit equipped with a heated seat element must be installed.
-
Occupant classification sensor (OCS) system components (seat cushion foam pad, bladder with pressure sensor and electronic control unit) are
calibrated to each other and are serviced as an assembly. The OCS system components are not to be installed separately. If a new OCS system,
OCS system component or seat cushion foam pad are needed, a new OCS system service kit (seat cushion foam pad, bladder with pressure sensor
and electronic control unit) must be installed as an assembly.
-
To identify between a production OCS system and a service OCS system (OCS service kit) inspect the electronic control unit (ECU) electrical
connector. A production OCS system allows the disconnect of the ECU electrical connector. A service OCS system (OCS service kit) has the ECU
electrical connector glued to the ECU. It cannot and should not be disconnected or altered.
-
If removing an OEM OCS, refer to the appropriate procedure.
-
The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate
