Mariner 2WD L4-2.3L VIN Z (2005)
Transmission Speed Sensor: Service and Repair
Output Shaft Speed (OSS) Sensor
Output Shaft Speed (OSS) Sensor
Material
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the 7 retainers and the LH splash shield.
^
To install, tighten to 10 Nm (89 inch lbs.).
3. Remove the Output Shaft Speed (OSS) sensor.
1
Disconnect the OSS electrical connector.
2
Remove the OSS sensor bolt.
3
Remove the OSS sensor.
^
To install, tighten to 13 Nm (10 ft. lbs.).
4. NOTE: When installing the sensor, lubricate the O-ring seal with clean transmission fluid.
