Mariner 2WD L4-2.3L VIN Z (2005)
Alignment: Service and Repair
Lean Correction
Lean Correction
NOTE: When installing a new coil spring, install a new spring with the same part number and the same spring code. Refer to the Vehicle
Certification (VC) label on the driver's side door.
1. Measure the distance from the wheelhouse opening to the center of the wheel and tire at the same point on both sides of the vehicle.
2. If the difference exceeds 10 mm (0.4 inch), a lean correction is necessary.
3. Remove the higher side coil spring.
1
If the original coil spring exceeds the height of the new one by 10 mm (0.4 inch), install the new coil spring in the vehicle.
2
If the original coil spring is shorter than the new one by 10 mm (0.4 inch), remove the low side coil spring from the vehicle.
4. Compare all 3 coil springs and select the 2 most evenly matched for installation.
