Mariner 2WD L4-2.3L VIN Z (2005)
Stabilizer Link: Service and Repair
Stabilizer Bar Link
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. NOTE: Use the hex holding feature to prevent the ball stud from turning while removing or installing the stabilizer bar link nut.
Remove the upper stabilizer bar link nut.
^
To install, tighten to 63 Nm (46 ft. lbs.).
3. NOTE: Use the hex holding feature to prevent the ball stud from turning while removing or installing the stabilizer link nut.
Remove the lower stabilizer bar link nut.
^
To install, tighten to 55 Nm (41 ft. lbs.).
4. NOTE: Inspect the stabilizer bar link ball joints and boots for wear. If necessary, install new parts.
Remove the stabilizer bar link.
5. To install, reverse the removal procedure.
