Mariner 2WD L4-2.3L VIN Z (2005)
2. Using the special tool, support the engine.
3. Remove the front-to-aft crossmember.
1
Remove the 2 transaxle front support insulator bolts.
^
To install, tighten to 90 Nm (66 ft. lbs.).
2
Remove the splash shield screw.
3
Remove the 2 front-to-aft crossmember bolts and nut.
^
To install, tighten to 90 Nm (66 ft. lbs.).
4
Remove the crossmember.
4. Remove the through-bolt and the transaxle front support insulator.
^
To install, tighten to 90 Nm (66 ft. lbs.).
5. If necessary, remove the 3 bolts and the transaxle front support insulator bracket.
^
To install, tighten to 55 Nm (41 ft. lbs.).
6. To install, reverse the removal procedure.
