Mariner 2WD L4-2.3L VIN Z (2005)
6. Apply glass primer to the same area that was prepped in the previous step. Allow 5 minutes to dry.
7. Cut the urethane adhesive applicator tip to specification.
8. NOTE:
-
Use caution when applying urethane adhesive. Apply to the outside edges of locating pins on the glass surface.
-
Use either a high-ratio electric or battery-operated caulk gun that will apply the urethane with less effort and a continuous bead.
Apply a bead of urethane adhesive starting at the bottom and work around to the sides of the rear quarter window glass.
9. Install the rear quarter window glass, aligning it to the marks previously made.
10. NOTE: The urethane adhesive must cure for a minimum of 1 hour before testing for air or water leaks.
After the urethane has cured, check for water leaks and add urethane adhesive where needed.
11. If necessary, remove excess urethane adhesive from the exterior surface of the quarter window glass.
12. Install the headliner.
LH Quarter Window Glass
13. If equipped, install the auxiliary climate control upper housing bracket and the bolt.
14. If equipped, install the auxiliary climate control housing.
