Mariner 2WD L4-2.3L VIN Z (2005)
8. Apply foam dam to the bottom of the windshield glass.
9. Cut the urethane adhesive applicator tip to specification.
10. NOTE: Use either a high-ratio electric or battery-operated caulk gun that will apply the urethane with less effort and a continuous bead.
Apply a bead of urethane adhesive to the sides and top of the windshield glass.
11. NOTE: Use either a high-ratio electric or battery-operated caulk gun that will apply the urethane with less effort and a continuous bead.
Apply a bead of urethane adhesive to the bottom of the windshield glass outside the foam dam.
12. Install the windshield glass, aligning it to the marks previously made.
13. NOTE: The urethane adhesive must cure for a minimum of 1 hour before testing for air and water leaks.
After the urethane adhesive has cured, check for water leaks and add urethane adhesive where needed.
14. If necessary, remove excess urethane adhesive from the exterior surface of the windshield glass.
15. Install the cowl panel grille.
16. Reposition the front portion of the headliner.
17. Position the 2 sun visors and 2 clips and install the 4 sun visor screws and 2 clip screws.
18. Install the interior rear view mirror.
19. Position the overhead console and install the 2 overhead console screws.
-
If equipped, connect the electrical connector.
20. Install the 2 windshield side garnish mouldings.
