Mariner 2WD L4-2.5L Hybrid (2010)
2. Remove the HCU. For additional information, refer to Hydraulic Control Unit (HCU) See: Hydraulic Control Assembly - Antilock
Brakes/Service and Repair.
3. Remove the jumper tube assembly bracket nut.
-
To install, tighten to 9 Nm (80 lb-in).
4. Disconnect the jumper tubes fittings from the HCU and remove the jumper tube assembly.
-
To install, tighten to 15 Nm (133 lb-in).
All vehicles
5. Remove the 4 ABS module screws and the ABS module.
-
To install, tighten to 2 Nm (18 lb-in).
6. To install, reverse the removal procedure.
