Mariner 2WD L4-2.5L Hybrid (2010)
4. Remove the engine plug bolt.
5. NOTE: When the crankshaft contacts the Crankshaft TDC Timing Peg, the No. 1 cylinder will be at Top Dead Center (TDC).
Install the Crankshaft TDC Timing Peg and turn the crankshaft clockwise until the crankshaft contacts the Crankshaft TDC Timing Peg.
6. Disconnect the Crankshaft Position (CKP) sensor electrical connector.
7. Remove the bolts and the CKP sensor.
Installation
1. NOTICE: Only hand-tighten the bolt or damage to the front cover can occur.
Install a 6 mm x 18 mm bolt in the crankshaft pulley and thread it into the front cover.
2. Install the CKP sensor and the 2 bolts.
-
Do not tighten the bolts at this time.
