Mariner 2WD L4-2.5L Hybrid (2010)
Fuel Pump Control Unit: Service and Repair
Fuel Pump Control Module
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. NOTE: The Fuel Pump (FP) control module is located near the left rear side of the fuel tank.
Disconnect the FP control module electrical connector.
3. NOTICE: Do not overtighten the fasteners or damage will occur.
Remove the 2 bolts and the FP control module.
-
To install, tighten to 5 Nm (44 lb-in).
4. To install, reverse the removal procedure.
