Mariner 2WD L4-2.5L Hybrid (2010)
Separate the hook-and-loop fasteners and remove the seat backrest trim cover.
11. Remove the backrest foam pad from the backrest frame.
12. Release the seat latch cable from the retractor.
13. Remove the 2 nuts and safety belt guide.
-
To install, tighten to 40 Nm (30 lb-ft).
14. Remove the nut and safety belt retractor.
-
To install, tighten to 40 Nm (30 lb-ft).
15. NOTE: Before installation, make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.
To install, reverse the removal procedure.
16. Check the active restraint system for correct operation. For additional information, refer to the appropriate Functional Test procedure in Safety
Belt System See: Testing and Inspection/Component Tests and General Diagnostics.
