Mariner 2WD L4-2.5L Hybrid (2010)
5. Install the driver side D-pillar trim panel.
1. Engage the D-pillar trim panel to the quarter trim panel.
2. Install the D-pillar trim panel.
3. Install the weatherstrip.
6. Connect the passenger side Safety Canopy(R) module electrical connector.
7. Install the passenger side D-pillar trim panel.
1. Engage the D-pillar trim panel to the quarter trim panel.
2. Install the D-pillar trim panel.
3. Install the weatherstrip.
8. Connect the passenger seat side air bag module electrical connector and then slide and engage the seat side air bag electrical connector locking
clip.
9. NOTICE: During passenger air bag module installation, make sure the passenger air bag module wire harness routing clip is attached to
the passenger air bag module. Failure to follow this instruction may result in wiring harness damage.
