Mariner 2WD L4-2.5L Hybrid (2010)
9. Remove the coil spring.
Installation
1. Align the coil spring and coil spring insulators to the previously noted position.
2. Using a suitable jackstand, carefully raise the wheel knuckle.
3. Install the new shock absorber lower bolt, washer and nut.
-
Tighten to 175 Nm (129 lb-ft).
4. Install the upper arm. For additional information, refer to Upper Arm See: Control Arm/Service and Repair/Rear Suspension/Upper Arm.
5. Connect the brake tube fitting to the wheel cylinder.
-
Tighten to 18 Nm (159 lb-in).
6. Install the brake hose bracket-to-wheel knuckle bolt.
-
Tighten to 22 Nm (16 lb-ft).
7. Bleed the rear wheel cylinder. For addition information, refer to Brakes and Traction Control for Component Bleeding.
