Mariner 2WD L4-2.5L Hybrid (2010)
Transmission Speed Sensor: Service and Repair
Output Shaft Speed (OSS) Sensor
Output Shaft Speed (OSS) Sensor
Removal
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. Remove the retainers and the LH splash shield.
3. Remove the transmission fluid drain plug and allow the transmission fluid to drain.
4. Install the transmission fluid drain plug.
-
Tighten to 12 Nm (106 lb-in).
5. Disconnect the transaxle vehicle harness electrical connector.
6. Remove the transaxle electrical wiring harness retainers from the transmission fluid pan stud bolts.
