Mariner 2WD L4-2.5L Hybrid (2010)
occur.
NOTE: There is a difference in the length of the head of the replacement cap strap bolts from the production bolts. The longer head pinion bolts
can be used in either location.
Remove and discard the 4 U-joint cap strap bolts and 2 cap straps and remove the front driveshaft.
-
To install, tighten to 23 Nm (17 lb-ft).
6. Index-mark the pinion and yoke to the driveshaft.
7. NOTE: Do not reuse the bolts for the rear U-joint flange. Install new bolts.
Remove and discard the 4 rear driveshaft-to-pinion flange bolts.
-
To install, tighten to 70 Nm (52 lb-ft).
8. With the help of an assistant, remove the center bearing support nuts and the driveshaft.
-
To install, tighten to 55 Nm (41 lb-ft).
9. NOTE: If a driveshaft is installed and driveshaft vibration is encountered after installation, index the driveshaft. For additional information, refer
to Differential Assembly &/or Axle Shaft Assembly &/or Drive/Propeller Shafts, Bearings and Joints.
To install, reverse the removal procedure.
