Mariner 2WD L4-2.5L Hybrid (2010)
5. NOTE: Make sure the clips are set completely within the cable adapter groove and fully seated.
Install the 2 gearshift cable clips.
6. Connect the gearshift cables to the transaxle gearshift control assembly.
7. Connect the SJB electrical connector and the 2 harness electrical connectors.
8. Adjust the gearshift cables. For additional information, refer to Manual Transmission/Transaxle &/or Clutch, M/T.
9. Install the floor console. For additional information, refer to Instrument Cluster / Carrier &/or Interior Moulding / Trim.
10. Install the RCM. For additional information, refer to Restraint Systems.
