Mariner 2WD L4-2.5L Hybrid (2010)
Transmission Mount: Service and Repair
Transaxle Rear Support Insulator
Transaxle Rear Support Insulator
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. Remove the transaxle rear support insulator bolt.
-
To install, tighten to 80 Nm (59 lb-ft).
3. Remove the 2 transaxle rear support insulator nuts.
-
To install, tighten to 80 Nm (59 lb-ft).
4. Remove the transaxle rear support insulator through bolt and washer.
-
To install, tighten to 115 Nm (85 lb-ft).
5. Remove the transaxle rear support insulator.
6. If necessary, remove the 3 bolts and the transaxle rear support insulator bracket.
-
To install, tighten to 48 Nm (35 lb-ft).
7. To install, reverse the removal procedure.
