Mariner 2WD V6-3.0L (2008)
Part 2
Removal and Installation
1. NOTE: Inspect the safety belt D-ring cover for damage. If the safety belt D-ring cover does not remain in place, install a new cover.
Remove the safety belt guide cover by squeezing the height adjuster buttons and pulling the cover out at the bottom.
2. Remove the safety belt bolt.
-
To install, tighten to 48 Nm (35 lb-ft).
3. Remove the quarter trim panel.
4. Position the rear door weatherstrip aside.
5. Remove the cover, the bolt and the C-pillar trim panel.
-
To install, tighten to 7 Nm (62 lb-in).
