Mariner 2WD V6-3.0L (2008)
7. Unzip the backrest trim cover zipper.
8. NOTE:
-
The inboard and outboard head restraint guides are not interchangeable.
-
The head restraint guides incorporate an alignment tab that must be aligned correctly when installed.
Squeeze together the tip of each head restraint guide and remove from the backrest frame.
Sixty percent seat backrest
9. Remove the 2 screws and the safety belt shield.
Both rear seat backrests
10. CAUTION: Use care when separating the seat backrest trim cover from the hook-and-loop strip or the hook-and-loop strip can be torn
from the seat backrest foam pad.
Separate the hook-and-loop strips and remove the seat backrest trim cover.
11. Remove the backrest foam pad from the backrest frame.
Sixty percent seat backrest
12. Release the seat latch cable from the safety belt retractor.
-
For installation, make sure the rear safety belt retractor is not in the automatic locking retractor (ALR) mode after installation.
13. Remove the 2 nuts and the safety belt guide.
-
To install, tighten to 40 Nm (30 lb-ft).
14. Remove the rear center safety belt retractor lower nut and the rear center safety belt retractor.