mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

Seat Backrest Cover - Front|Page 6641 > < Seat Backrest Cover - Front|Page 6639
Page 5
background image

Seat Cushion - Front, Passenger (Part 2)

Removal and Installation

WARNING:

-

Always wear eye protection when servicing a vehicle. Failure to follow this instruction may result in serious personal injury.

-

Never probe the electrical connectors on air bag, safety canopy or side air curtain modules. Failure to follow this instruction may result in
the accidental deployment of these modules, which increases the risk of serious personal injury or death.

-

If the seat side air bag cover has been damaged or separated from its mounting, or if the air bag material has been exposed, install a new
seat side air bag module. Never try to repair the seat side air bag module. Failure to follow these instructions may result in the seat side
air bag deploying incorrectly, which increases the risk of serious personal injury or death in a crash.

-

Front seat backrest trim covers installed on seats equipped with seat side air bags cannot be repaired. A new trim cover must be installed.
Cleaning is permissible. Failure to follow these instructions may result in the seat side air bag module deploying incorrectly and increase
the risk of serious personal injury or death in a crash.

NOTE:

-

If a side air bag deployment took place, a new seat back pad, trim cover and side air bag module and nuts must be installed. The seat back frame
should be replaced if necessary.

-

The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a supplemental restraint system (SRS) fault.

-

The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

-

Driver seat shown, passenger seat similar.

1. Depower the SRS.
2. Release the 2 locking tabs and remove the head restraint.

3. NOTE:  The head restraint guides are not interchangeable.

Pull and remove the 2 head restraint guides.

4. If equipped, remove the manual lumbar adjust knob.
5. Release the J-clip at the bottom of the front seat backrest trim cover.

Seat Backrest Cover - Front|Page 6641 > < Seat Backrest Cover - Front|Page 6639