Mariner 2WD V6-3.0L (2008)
Assembly
All seats
1. Bend the retaining tab back on the pressure sensor component bracket.
Seat with an original equipment OCS system
2. CAUTION:
-
Failure to route the seat occupant classification sensor (OCS) components through the correct seat cushion support opening can cause
component failure.
-
While positioning the seat cushion frame and occupant classification sensor (OCS), be careful not to damage any of the components.
Failure to do so can result in component failure.
Feed the OCS system components (pressure sensor and hose) through the opening in the seat cushion frame.
3. Align the OCS bladder to the seat cushion frame.
4. Install the 2 pin-type retainers to the OCS bladder and seat cushion frame.
5. NOTE: Make sure the pressure sensor hose is not kinked during installation.
