Mariner 2WD V6-3.0L (2008)
Part 2
Disassembly and Assembly
WARNING:
-
Never probe the electrical connectors on safety belt buckle/retractor pretensioners or adaptive load limiting retractors. Failure to follow
this instruction may result in the accidental deployment of the safety belt pretensioners or adaptive load limiting retractors, which
increases the risk of serious personal injury or death.
-
Never probe the electrical connectors on air bag, safety canopy or side air curtain modules. Failure to follow this instruction may result in
the accidental deployment of these modules, which increases the risk of serious personal injury or death.
NOTE:
-
The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
1. Remove the front seat.
2. Remove the seat backrest.
3. Remove the safety belt buckle pretensioner.
-
Disconnect and detach the safety belt buckle pretensioner and buckle switch electrical connectors from the seat track.
-
Detach the wiring harness pin-type retainer.
-
Route the wiring harness from between the seat track and cushion frame.
4. Disconnect the electrical connector(s).
-
Disconnect the seat position sensor electrical connector.
-
If equipped, disconnect the power seat track electrical connector and detach the wiring harness.
5. Remove the 4 bolts and seat track.
-
To install, tighten to 23 Nm (17 lb-ft).
6. If equipped, disconnect the cushion heater mat electrical connector.
7. CAUTION: Use care when separating the seat cushion trim cover from the hook-and-loop strips or the hook-and-loop strips may be torn
from the seat cushion foam pad.
NOTE: If equipped, note heater mat wire harness routing for installation.
Release the trim cover retainers and remove the cushion trim cover.
-
Separate the hook-and-loop strips.
8. Remove the cushion foam pad.
9. Release the locking tab and remove the heated seat relay from the bracket on the cushion frame.
-
Disconnect the relay electrical connector.
10. To assemble, reverse the disassembly procedure.
