Mariner 2WD V6-3.0L (2008)
3. Disconnect the rear wheel speed sensor electrical connector.
4. Remove the rear wheel speed sensor harness from the harness retainer.
5. Remove the 3 rear wheel speed sensor harness bolts.
^
To install, tighten to 9 Nm (80 lb-inch).
6. NOTE: Clean off any debris that may have collected around the sensor before removal.
Remove the rear wheel speed sensor bolt from the wheel knuckle.
^
To install, tighten to 9 Nm (80 lb-inch).
7. Remove the rear wheel speed sensor.
8. NOTE: Thoroughly clean the mounting surface.
To install, reverse the removal procedure.
