Mariner 2WD V6-3.0L (2008)
Installation
1. Install the brake pads onto the caliper and position the brake caliper onto the anchor plate.
2. Install the 2 brake caliper guide pin bolts and the 2 bushing caps.
^
Tighten the bolts to 50 Nm (37 lb-ft).
3. NOTE: If present, the 2-tabbed end of the brake pad anti-rattle spring must be installed first.
Install the brake pad anti-rattle spring using the following procedure:
1. Insert the tab of the spring into the brake caliper cavity.
2. Twist the tab into the cavity (LH side in the upper brake caliper cavity, RH side in the lower brake caliper cavity).
4. Rotate the brake pad anti-rattle spring and position the upper portion onto the anchor plate.
5. Position the lower portion of the brake pad anti-rattle spring onto the anchor plate.
6. Push down and inward until the upper and lower ends of the anchor housing spring are latched and seated in the brake caliper cavities.
7. NOTE: The latch MUST be positioned as shown.
Verify that the brake pad anti-rattle spring is correctly latched by pulling on the spring.
8. NOTE: Make sure that the brake flexible hose is not twisted.
Install the brake flexible hose to the brake caliper.
^
Tighten to 20 Nm (15 lb-ft).
9. Install the wheel and tire.
10. Bleed the brake system.
