Mariner 2WD V6-3.0L (2008)
1. Release the parking brake cable tension.
Rear disc brake vehicles
2. With the vehicle in NEUTRAL, position it on a hoist.
Rear drum brake vehicles
3. Remove the rear brake shoes.
All vehicles
4. Disconnect the parking brake cable from the cable connector and the equalizer bracket by compressing the cable conduit locking tabs.
5. Detach the cable-to-fuel tank strap pin type retainer.
6. Remove the 2 parking brake cable bracket bolts.
^
To install, tighten to 23 Nm (17 lb-ft).
Rear drum brake vehicles
7. Compress the rear parking brake cable conduit locking tabs and pull the cable assembly through the brake backing plate.
Rear disc brake vehicles
8. NOTE: During installation, make sure parking brake cable is seated correctly as shown.
Release the rear parking brake cable end from the parking brake actuator lever and compress the cable conduit locking tabs.
All vehicles
9. To install, reverse the removal procedure.
Parking Brake Cable - Rear, RH
Parking Brake Cable - Rear, RH
NOTE: Rear disc shown, rear drum similar.
