Mariner 2WD V6-3.0L (2008)
Cooling Fan Motor and Shroud (Part 2)
Removal and Installation
All vehicles
1. With vehicle in NEUTRAL, position it on a hoist.
2.3L vehicles only
2. Drain the cooling system.
All vehicles
3. Remove the front bumper cover.
4. Remove the front impact severity sensor.
5. Remove the 2 pin-type retainers.
6. Remove the 4 bolts and the 2 radiator brackets.
^
To install, tighten to 10 Nm (89 lb-in).
7. NOTE: Mark the hood latch position prior to removal of the bolts.
Loosen the nut, remove the 2 bolts and position aside the hood latch.
^
To install, tighten to 9 Nm (80 lb-in).
8. Remove the 2 wiring harness retainers from the front bumper bracket.
