Mariner 2WD V6-3.0L (2008)
4. Install the 2 oil pan-to-front cover bolts.
^
Tighten to 25 Nm (18 lb-ft).
5. Remove the oil pan drain plug and drain the engine oil.
^
Install the plug and tighten to 26 Nm (19 lb-ft).
6. Install the speed control actuator and 3 nuts.
^
Tighten to 9 Nm (80 lb-in).
7. Attach the 2 wire harness retainers to the speed control actuator mounting studs.
8. Connect the A/C pressure switch electrical connector.
9. Install the engine support insulator.
10. Install the LH and RH valve covers.
11. Connect the CMP electrical connector.
12. Connect the CKP electrical connector.
13. Install the catalyst monitor sensor electrical connector bracket and the nut.
^
Tighten to 10 Nm (89 lb-in).
^
Attach the wiring harness retainer.
14. Position the RH accessory drive belt idler pulley and bracket and attach the wiring harness retainer.
^
Install the 3 bolts and tighten to 25 Nm (18 lb-ft).
15. Install the center accessory drive belt idler pulley.
^
Tighten to 25 Nm (18 lb-ft).
16. Install the LH accessory drive belt idler pulley.
^
Tighten to 47 Nm (35 lb-ft).
17. Install the accessory drive belt tensioner and the bolt.
