Mariner 2WD V6-3.0L (2008)
Removal and Installation
NOTE: The LH temperature blend door actuator is present on dual-zone electronic automatic temperature control (EATC) vehicles to control the LH
temperature blend door only. Vehicles equipped with electronic manual temperature control (EMTC) are not equipped with this actuator. For EMTC
vehicles, refer to Temperature Blend Door Actuator - RH.
1. Disconnect the LH temperature blend door actuator electrical connector.
2. Remove the 2 LH temperature blend door actuator screws.
-
To install, tighten to 3 Nm (27 lb-in).
3. Remove the LH temperature blend door actuator.
4. To install, reverse the removal procedure.
