Mariner 2WD V6-3.0L (2008)
Air Bag Deactivation Indicator: Service and Repair
PASSENGER AIR BAG DEACTIVATION (PAD) INDICATOR
Removal and Installation
WARNING: To reduce the risk of accidental deployment, do not use any memory saver devices. Failure to follow this instruction may result in
serious personal injury or death.
NOTE:
-
The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a SRS fault.
-
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic
procedure again.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
The passenger air bag deactivation indicator is part of the upper I/P center finish panel.
1. Depower the SRS.
2. NOTE: The passenger air bag module is not shown for clarity.
Open and lower the glove compartment door to gain access to the passenger airbag deactivation (PAD) indicator electrical connector.
-
Disconnect the PAD indicator electrical connector.
