Mariner 2WD V6-3.0L (2008)
Accelerator Pedal: Service and Repair
ACCELERATOR PEDAL AND SHAFT
Removal and Installation
WARNING: Keep the sliding inner cable of the accelerator cable, the accelerator pedal and the pedal shaft free of contact with surrounding
components such as wiring, hoses, sound insulation and floor carpeting. Contact in these areas may prevent movement of the accelerator cable,
reducing the ability to decelerate the vehicle. Failure to follow these instructions may result in serious personal injury to the vehicle
occupant(s).
NOTE: The accelerator pedal and shaft should travel smoothly from idle to wide-open throttle positions. Hesitation on return or prevention of return to
the idle position must not occur.
1. Remove the accelerator cable from the accelerator pedal.
2. Remove the 2 bolts and the accelerator pedal and shaft assembly.
-
To install, tighten to 9 Nm (80 lb-in).
3. To install, reverse the removal procedure.
