Mariner 2WD V6-3.0L (2008)
Crankshaft Position Sensor: Service and Repair
CRANKSHAFT POSITION (CKP) SENSOR
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the 5 bolts and the RH splash shield.
-
To install, tighten to 9 Nm (80 lb-in).
3. Disconnect the crankshaft position (CKP) sensor electrical connector.
4. Remove the bolt and the CKP.
-
To install, tighten to 10 Nm (89 lb-in).
-
Inspect the O-ring seal and install new as necessary.
5. NOTE: Lubricate the CKP O-ring seal with clean engine oil.
To install, reverse the removal procedure.