Mariner 2WD V6-3.0L (2008)
Engine Ignition - LH
Removal and Installation
RH side
1. NOTE: The upper intake manifold must be removed to access the RH ignition coils only.
Remove the upper intake manifold.
Both sides
2. Disconnect the ignition coil electrical connectors.
3. NOTE: When removing the ignition coil-on-plugs, a slight twisting motion will break the seal and ease removal.
Remove the bolts and the ignition coils.
-
To install, tighten to 7 Nm (62 lb-in).
4. To install, reverse the removal procedure.
-
Apply a small amount of dielectric grease to the inside of the ignition coil boots before attaching to the spark plugs.
