Mariner 2WD V6-3.0L (2008)
1. Depower the SRS.
2. Using a 3-mm Allen wrench or a suitable tool, place it in the driver air bag module release hole on the underside of the steering wheel.
3. CAUTION: During driver air bag module removal, make sure all 3 driver air bag module hooks are released from the steering wheel
wire clip. Failure to do so may cause damage to the driver air bag module and/or the steering wheel.
NOTE: The driver air bag module is removed for clarity.
Position the 3-mm Allen wrench or suitable tool against the wire clip and push inward disengaging the wire clip from the 3 driver air bag module
hooks.
4. Disconnect the horn electrical connector. Then disconnect the 2 driver air bag module electrical connectors and remove the driver air bag module.
Installation
1. CAUTION: The driver air bag module electrical connectors are unique and cannot be reversed when connected to the driver air bag
module. Match the electrical connector key to the keyway in the driver air bag module. Do not force the electrical connectors into the
driver air bag module. Damage to the connector or component may occur.
Install the driver air bag module electrical connectors fully into the driver air bag module. Then connect the horn electrical connector.
2. NOTE:
-
Make sure the driver air bag module wiring harness is routed away from the driver air bag module hooks during installation.
-
Audible clicks will be heard when the 3 wire clips are seated in the 3 driver air bag module hooks.
