Mariner 2WD V6-3.0L (2008)
Failure to follow this instruction may result in the air bag deploying incorrectly, which increases the risk of serious personal injury or death in a
crash.
-
To reduce the risk of accidental deployment, do not use any memory saver devices. Failure to follow this instruction may result in serious personal
injury or death.
NOTE:
-
The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a supplemental restraint system (SRS) fault.
-
The supplemental restraint system (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
-
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic
procedure again.
1. Depower the SRS.
2. Open and lower the glove compartment door.
3. Remove the 2 passenger air bag module bolts.
-
To install, tighten to 8 Nm (71 lb-in).
4. CAUTION: Do not handle the passenger air bag module by grabbing the edges of the deployment door. Failure to follow these
instructions may result in component damage and/or system failure.
NOTE:
-
During passenger air bag module installation, make sure all the deployment door clips are fully seated into the instrument panel.
-
Use care when removing the passenger air bag module from the instrument panel (I/P). The passenger air bag module can drop down during
removal and the passenger air bag module rear bracket can scratch the front of the I/P.
Through the glove compartment opening, release the passenger air bag module deployment door clips while pushing the passenger air bag module
out of the I/P.
5. CAUTION:
-
During passenger air bag module installation, make sure the passenger air bag module wire harness routing clip is attached to the
passenger air bag module. Failure to follow this instruction may result in wiring harness damage.
-
The passenger air bag module electrical connectors are unique and cannot be reversed when connected to the passenger air bag
module. Match the electrical connector key to the keyway in the passenger air bag module. Do not force the electrical connectors into
the passenger air bag module. Failure to follow these instructions may result in component and/or connector damage.
Remove the passenger air bag module.
1
Disconnect the 2 passenger air bag module electrical connectors.
2
Detach the wire harness routing clip and remove the passenger air bag module.
6. To install, reverse the removal procedure.
