Mariner 2WD V6-3.0L (2008)
8. Install the 2 bolts to the safety canopy module tether bracket at the C-pillar.
-
Tighten to 8 Nm (71 lb-in).
9. If the vehicle is equipped with a rear window wiper assembly, position the hose and attach the hose clip.
10. If the vehicle is equipped with a moonroof, connect the moonroof rear drain hose.
11. Connect the safety canopy module electrical connector and attach the connector to the D-pillar.
12. Install the safety canopy module wiring clip to the roof panel brace.
13. Install the remaining 2 safety canopy module bolts near the ignitor (between the C- and D-pillars).
-
Tighten to 8 Nm (71 lb-in).
