Mariner 2WD V6-3.0L (2008)
Remove the steering wheel.
5. NOTE: The upper steering column shroud is a 2-piece design and must be removed as an assembly.
Release the tabs and remove the 2-piece upper steering column shroud as an assembly.
6. Remove the 3 lower steering column shroud screws. Then release the tilt column locking lever and remove the lower steering column shroud.
7. Disconnect the clockspring electrical connector.
8. Remove the 2 screws and the clockspring.
Installation
1. CAUTION: If installing a new clockspring, do not remove the clockspring anti-rotation key until the steering wheel is installed. If the
anti-rotation key has been removed before installing the steering wheel, the clockspring must be centered. Failure to follow this
instruction may result in component damage and/or system failure.
Install the clockspring and the 2 screws.
2. Connect the clockspring electrical connector.
3. Install the lower steering column shroud and the 3 screws.
4. Tilt the steering column down and lock the tilt column locking lever.
5. Attach the upper steering column shroud to the lower steering column shroud.
6. WARNING: If the clockspring is not correctly centralized, it may fail prematurely. If in doubt, repeat the centralizing procedure.
Failure to follow these instructions may increase the risk of serious personal injury or death in a crash.
CAUTION:
-
To prevent component damage and/or system failure, when reusing a clockspring it must be centered.
-
Do not over-rotate the clockspring inner rotor. The internal ribbon wire is connected to the clockspring rotor. The internal ribbon
wire acts as a stop and can be broken from its internal connection. Failure to follow this instruction may result in component damage
and/or system failure.
If a new clockspring was installed and the anti-rotation key has not been removed proceed to step 8.
If a new clockspring was installed and the anti-rotation key has been removed before the steering wheel is installed or the same clockspring is
being installed, rotate the clockspring inner rotor counterclockwise and carefully feel for the ribbon wire to run out of length with slight resistance.
Stop rotating the clockspring inner rotor at this point.
7. Starting with the clockspring inner rotor, wiring and connector in the 12 o'clock position, rotate the inner rotor clockwise through 4 revolutions to
center the clockspring.
Verify that the clockspring is correctly centered by observing that after 4 revolutions:
-
the clockspring rotor window is in the 4 o'clock position and the yellow indicator shows in the window.
-
the 2 arrows located on the inner and outer rotor of the clockspring line up in the 6 o'clock position.
-
the clockspring inner rotor, wiring and connector are in the 12 o'clock position.
