Mariner 2WD V6-3.0L (2008)
Removal
WARNING:
-
To reduce the risk of accidental deployment, do not use any memory saver devices. Failure to follow this instruction may result in serious
personal injury or death.
-
Install a new occupant classification sensor (OCS) system service kit as a complete assembly. Never install only part of the kit
components. Failure to follow this instruction may result in incorrect operation of the OCS system and increases the risk of serious
personal injury or death in a crash.
CAUTION: It is necessary to carry out the occupant classification sensor (OCS) system reset when a front passenger seat backrest is
separated from the seat cushion, the seat cushion is disassembled, a new trim cover is installed or an OCS service kit is installed. A scan tool
is used to trigger the active command to carry out the OCS system reset. Failure to follow these instructions may result in incorrect operation
of the OCS system and may cause system failure.
NOTE:
-
The heated seat element on the front passenger seat cushion is not serviceable separately. If a new heated seat element is needed on the front
passenger seat cushion, a new occupant classification sensor (OCS) service kit equipped with a heated seat element must be installed.
-
Occupant classification sensor (OCS) system components, seat cushion foam pad, bladder with pressure sensor and electronic control unit (ECU),
are calibrated to each other and are serviced as an assembly. The OCS system components are not to be installed separately. If a new OCS system,
OCS system component or seat cushion foam pad are needed, a new OCS system service kit (seat cushion foam pad, bladder with pressure sensor
