Mariner 2WD V6-3.0L (2008)
-
If removing an original equipment manufacturer (OEM) occupant classification sensor (OCS), refer to the appropriate procedure.
-
The seat wiring harness will be reused. The OCS service kit connector connects to the seat wiring harness electronic control unit ECU connector.
The pressure sensor seat wiring harness connector will be left unplugged and secured by a tie strap.
-
The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic
procedure again.
1. Depower the SRS.
2. Remove the passenger seat.
3. NOTE: The seat wiring harness will be reused.
Disconnect the electrical connector(s) and wiring clips.
1
Disconnect the seat wire harness OCS electrical connector from the service part OCS electrical connector.
2
Release the 2 wiring clips on the wiring harness from the seat cushion pan.
3
If equipped with heated seats, disconnect the heated seat module electrical connector, release the wiring clip on the wiring harness from the
seat cushion pan, and disconnect the 2 seat cushion element electrical connectors.
4. Remove the 4 seat cushion bolts retaining the seat cushion to the seat track.
5. CAUTION: While positioning the seat cushion pan and occupant classification sensor (OCS) assembly, be careful not to damage any of
the components. Failure to follow these instructions may result in incorrect operation of the OCS system and may cause system failure.
Remove the seat cushion and pan assembly.
-
To aid in removal, recline the seat.
6. CAUTION: Use care when separating the seat upholstery from the hook-and-loop strip, or the hook-and-loop strip can be torn from the
seat cushion foam pad.
Detach the seat cushion trim cover J-clips from the seat cushion pan and remove the seat cushion trim cover.
