Mariner 2WD V6-3.0L (2008)
3. Remove the front-to-aft crossmember.
1
Remove the 2 transaxle front support insulator bolts.
^
To install, tighten to 90 Nm (66 lb-ft).
2
Remove the splash shield screw.
3
Remove the 2 front-to-aft crossmember bolts and the nut.
^
To install, tighten bolts to 90 Nm (66 lb-ft).
^
To install, tighten nut to 175 Nm (129 lb-ft).
4
Remove the crossmember.
4. Remove the through bolt and the transaxle front support insulator.
^
To install, tighten to 115 Nm (85 lb-ft).
5. If necessary, remove the 3 bolts and the transaxle front support insulator bracket.
^
To install, tighten to 48 Nm (35 lb-ft).
6. To install, reverse the removal procedure.
