Mariner 2WD V6-3.0L (2008)
14.
Route the shortened vent line and spider screen (vent cap) as shown in Figure 1.
15.
Push the spider screen (vent cap) at least 2" (50 mm) into the open subframe and body section alignment hole.
16.
Secure the vent line to the fuel tank strap with a plastic tie strap.
17.
Reposition the filler pipe into its original position.
18.
Install the lower filler pipe mounting screw and tighten to 89 lb-in (10 N.m).
19.
Install the two (2) upper filler pipe mounting screws and tighten to 27 lb-in (3 N.m).
20.
Install the fuel filler cap.
21.
Reinstall the wheel and tighten to 98 lb-ft (133 N.m).
22.
Lower the vehicle from the hoist.
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
IMPORTANT: Warranty coverage limits/policies are not altered by a TSB. Warranty coverage limits are determined by the identified causal part.
OPERATION
DESCRIPTION
TIME
080505A
2005-2008 Escape,
0.7 Hr.
Escape Hybrid And
Mariner, 2006-2008
Mariner Hybrid: Relocate
Fuel Filler Vent Hose.
Includes Time to Remove
Left Rear Wheel, Fuel Cap
And Partially Remove The
Fuel Filler Pipe And Shield
(Do Not Use With 9030A)
DEALER CODING
CONDITION
BASIC PART NO.
CODE
9A089
55
Disclaimer
