Mariner 2WD V6-3.0L (2008)
Windshield Washer Pump: Service and Repair
Washer Pump
WASHER PUMP
Exploded View
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the RH front fender splash shield.
3. Disconnect the washer pump electrical connector.
4. WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical
advice. Failure to follow these instructions may result in serious personal injury.
CAUTION: To prevent damage to the connector, do not use hand tools to remove/install the washer pump hose.
NOTE: To prevent spilling windshield washer fluid, drain the windshield washer reservoir before washer pump removal.
Disconnect the washer pump hoses.
-
Gently twist the lock ring until the ring has rotated approximately 90 degrees.
-
The hose should slide easily out of the connection.
-
To install, make sure the hoses are fully seated and locked into place.