Mariner 2WD V6-3.0L VIN 1 (2006)
Keyless Entry Transmitter: Service and Repair
REMOTE KEYLESS ENTRY TRANSMITTER PROGRAMMING
CAUTION: All remote keyless entry (RKE) transmitters must be programmed at the same time.
1. The vehicle must be electronically unlocked before entering program mode (via the RKE transmitter or the door lock control switch while the
driver door is open).
2. Turn the ignition switch from OFF to RUN 8 times within 10 seconds, with the eighth turn ending in RUN. If the module successfully enters
program mode, it locks and then unlocks all doors.
3. Within 20 seconds, press any button on an RKE transmitter; and the doors lock and then unlock to confirm that each remote transmitter is
programmed. Repeat this step for each RKE transmitter.
4. If the door locks do not respond for any RKE transmitter, wait several seconds and press the button again. If the door locks still fail to respond,
refer to Inspection and Verification. Make sure that no more than the maximum number of RKE transmitters are attempted to be programmed.
See: Body and Frame/Locks/Power Locks/Testing and Inspection/Initial Inspection and Diagnostic Overview/Inspection and Verification
5. Exiting the programming mode is accomplished if 1 of the following occurs:
-
The key transitions to the OFF position.
-
20 seconds have passed since entering programming mode or since the last RKE transmitter was programmed.
-
The maximum number of RKE transmitters are programmed.
