Mariner 2WD V6-3.0L VIN 1 (2006)
ONE TIME CLAIM REIMBURSEMENT FOR LOCALLY OBTAINED 5/8 INCH AUGER BIT
Dealers will be reimbursed for the cost of one auger bit. For this reimbursement, the actual cost of the auger bit must be submitted on one of the initial
claims for this recall using the miscellaneous expense code "OTHER".
NOTE:
Any additional reimbursement claims for an auger bit will result in a charge-back.
Attachment II - Labor and Parts Information
LABOR ALLOWANCES
REQUIRED SPECIAL TOOLS
To perform this recall, the technician will require a special drill guide and a 5/8 inch auger bit.
^
Drill Guide: On or about May 12, 2006, one drill guide tool was sent to each dealer at no cost. The tool was shipped by DHL Express Ground
Transportation and addressed, "ATTN: Service Manager". Questions regarding the drill guide should be directed to the Special Service Support
Center.
^
5/8 Inch Auger Bit: This tool must be obtained locally. For tool cost reimbursement, refer to Attachment I of this document.
PARTS REQUIREMENTS / ORDERING INFORMATION
No parts are required for this recall.
Attachment III - Technical Information
OVERVIEW
