Mariner 2WD V6-3.0L VIN 1 (2006)
Trim Panel: Service and Repair
B-Pillar Trim Panel
B-PILLAR TRIM PANEL
Removal and Installation
1. NOTE: Inspect the safety belt D-ring cover for damage. If the safety belt D-ring cover does not remain in place, install a new cover.
Remove the safety belt D-ring cover and remove the safety belt bolt.
-
To install, tighten to 53 Nm (39 lb-ft).
2. Position the front and rear door weatherstrips aside.
3. Remove the cover, bolt and the upper B-pillar trim panel.
-
To install, tighten to 7 Nm (62 lb-in).
4. Remove the 2 pin-type retainers and the front door scuff plate trim panel.
5. Remove the pin-type retainer and the rear door scuff plate trim panel.
6. Remove the lower B-pillar trim panel.
7. To install, reverse the removal procedure.
