Mariner 2WD V6-3.0L VIN 1 (2006)
Keyless Entry Key-Pad: Service and Repair
Autolock and Horn Chirp Programming
AUTOLOCK AND HORN CHIRP PROGRAMMING
Using the Keyless Entry Keypad (if equipped)
NOTE: A manual enable/disable mode allows the autolock feature to be turned off and on.
1. Enter the 5-digit permanent entry code into the keyless entry keypad.
2. Within 5 seconds of entering the code, press and hold the 7/8 button on the keypad.
3. Within 5 seconds of Step 2, and while holding the 7/8 button, press the 3/4 button on the keypad and release it.
4. NOTE: If the autolock is disabled, the horn chirps once. If the autolock feature is enabled, the horn chirps once shortly and then sounds a second
time for a longer sound of the horn once the above sequence is completed.
Within 5 seconds of Step 3, release the 7/8 button on the keypad.
Using the Ignition Lock Cylinder
1. Close all doors.
2. Confirm that the key is in the OFF position.
3. Turn the key from OFF to ON.
4. NOTE: Steps 4 through 8 must be carried out within 30 seconds.
Press the door lock control switch UNLOCK button 3 times.
5. Turn the key from ON to OFF.
6. Press the door lock control switch UNLOCK button 3 times.
7. Turn the key from OFF to ON.
8. Verify that the horn chirps. This indicates the system is in the enable/disable mode and is ready to accept program changes.
9. Press the door lock control switch UNLOCK button once, then the LOCK button once to toggle the autolock feature ON/OFF.
10. Verify that the horn chirps 1 time. There should be only one chirp indicating that the autolock/relock feature is disabled. If 1 chirp is heard,
followed by a longer sound of the horn, the autolock feature has just been enabled. Return to Step 9.
11. Turn the key to the OFF position to exit the enable/disable mode.
12. Exit the vehicle and verify that the horn chirps once to indicate that a feature is changed and that autolock has been enabled/disabled.
